Auluminator Features and Specs

Auluminator Belt Trailers

Features and Specs for the Auluminator

  • 2 ply belt flaps full width of trailer floor
  • Bolt on 5th wheel plate
  • Hydraulic Gear drive 130,000 in-lb, 18,000 pound radial load
  • 2 15/16" rear drive shaft, with weld on sprockets and weld on splined hub
  • Top hinge hydraulic main gate, with center knife gate and cylinder locks, 12"
  • clearance above top rail
  • Floor liner is 3/8" thick UHMW plastic
  • Sides fully lined with 3/16" HMW plastic all the way to the top
  • Extended rear discharge with wings on rear of trailer
  • Hydraulic pressure line filter, manual or electric control valve
  • Hydraulic floor speed control
  • Side and slope sheets are post and hat riveted aluminum construction
  • 50,000 lb landing gear
  • ABS brake system
  • 11 x 22.5 on 10 bolt hub pilot aluminum rims
  • Hendrickson Intraax Air ride suspension with 25,000 lb axles
  • Various axle combinations available
  • Shur-Loc roll tarp
  • D.O.T. lighting, Reflective tape
  • Other custom options available - Just ask!!